ridder 0 Posted February 8, 2010 Report Share Posted February 8, 2010 I've just purchased and have a problem I'm hoping some seasoned users may know the solution to. When I use Ubot to log into a secured site, I need to then manually click a link inside that site to continue. The link produces a popup page inside Internet Explorer. Normally if i were navigating the site using explorer, I'd be taken to the next page upon clicking that link. But using UBot the popup page is asking me to log in all over again. I suppose because this new page is outside of Ubot. I hope there's a work-around to this problem? Quote Link to post Share on other sites
Gogetta 263 Posted February 9, 2010 Report Share Posted February 9, 2010 I've just purchased and have a problem I'm hoping some seasoned users may know the solution to. When I use Ubot to log into a secured site, I need to then manually click a link inside that site to continue. The link produces a popup page inside Internet Explorer. Normally if i were navigating the site using explorer, I'd be taken to the next page upon clicking that link. But using UBot the popup page is asking me to log in all over again. I suppose because this new page is outside of Ubot. I hope there's a work-around to this problem? You could do a few things here, but its probably best to just extract the link from the page and then navigate to it. So something like... Choose By Attribute --> Set Variable --> Scrape Chosen Attribute --> Nav to Variable. Tip: When setting the variable leave the value blank and click ok. Then click on the command place holder, next locate the link on the page and right click and click scrape chosen attribute. You will need to scrape the href. Good Luck! Example: http://i49.tinypic.com/2ihl11d.gif Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.