TJ check PM.
to explain some of the return commands to ubot a bit better,
list from large table
return large table csv
large table return
with the above commands you can specify a range for example row 10 to row 100 or you can return the full large table by specify 0 0 in row start and row finish.
Large table bulk input
I created this command to enable multithreading to be stored to a single main table.
plugin command("Bigtable.dll", "Large Table bulk input", "bulkinputtest", "1,2,3,4,5,6,7,8,9")
the above is not the best way to use this if you adding more than one line to large table in a thread the following is
plugin command("Bigtable.dll", "Large Table bulk input", "bulkinputtest", %somethingscraped)
so say for example you where scraping and then carrying a inner scrape of that you would add to a list like this
add item to list(%somethingscraped, "scrape1,scrape2,scrape3,scrape4", "Don\'t Delete", "Local")
so each line in the local list is a comma separated row of your scrapes. the local list is then added to the table.
check the example code to see how it works.
Thanks to everyone else for feedback i'm going to do a update later in the week to improve efficiency of a couple of the commands which were added at the last min to prove concept(most average users wont notice a difference only the heavy scrapers). If you have any suggestions for other commands let me know.